2015 New High quolality perforating ruleT-306
for use on offset presses
1 good quality
2 high quality
3 fast delivery
4 best after sale service
Sample for your reference:
Type Slit: http://hz.productposting.alibaba.com/product/product_detail.htm?id=1912911003
Type Score: http://hz.productposting.alibaba.com/product/product_detail.htm?id=1914184951
INSTRUCTIONS FOR APPLYING PERFECT PERF
NOTE:It is recommended that a good perforation guide be included in
the printing plate.
STEP 1:Make certain that the impression cylinder is clean and free
from oil or grease.
STEP 2:After positioning image on sheet,transfer image to the
STEP 3:Cut off the amount of Perfect Perf to rule required and
remove the paper backing to expose the adhesive coating.
STEP 4:Following the guideline ,apply the Perfect Perf to the
impression cylinder .Once applied the adhesive wll hold the rude in
STEP 5:Overlay the rule with the clear film tape furnishined in the
spool.On the first impression the sutting or scoring adge will
puncture through the tape.
Note:After securing the rule to the cylinder ,it is advisable to
reduce the pressure between the impression cylinder and gradually
increase until the desired printing and perfrating results are
acquired . By increasing the cyclinder pressure it will naturally
improve the perforation but could affect the print
quality.Therefore depending on the thickness of stock being used it
may be necessary to adjust the rule height by building up the rule
as suggested below.
If the cut is considered too light, apiece of clear film tape
should be applied underneath the rule to adjust the height.Be
certain to trim away any extra tape .
If the sheet will not release from the rule or if the cut is
considered too heavy,another piece of clear film tape should be
applied over the rule.
CAUTION:BEFORE TURNING ON THE PRESS MAKE CERTAIN THERE IS CLEARANCE
BETEEN PRESS PARTS AND THE APPLIED METAL RULE.
EASY INSTRUCTIONS FOR REPEAT JOBS
Prepare the job for running the ordinary procedure.
STEP 1:Apply Perfect Perf to printed sheet or thin plastic sheet
using the perforation guideline.
STEP 2:Place the sheet in the press feeder and open the sheet
detectors wide enough to allow passage of the metal rule.
STEP 3:Coat the impression cylinder area behind the grippers with a
generous amount of rubber cement. Apply a thinner coat of rubber
cement on the impression cylinder over the area the sheet will
STEP 4:Slowly feed the sheet through the press.As it enters the
grippers turn off the press and continue the cycle by hand.
STEP 5:Cut the sheet directly behind the grippers with a sharp
blade.The sheet will now stay fastened to the cylinder.Using rubber
cement fasten any loose edges or corners.
STEP 6:Adjust pressure to allow for the extra sheet and your job is
now ready to tun.If aplastic sheet is used it can be remored and
We are the manufacturer of printing ink with our own professional
R&D Development. We are aimed at producing high quality, and
eco-friendly products for our customers
Our advertisement on the cover of Printing Technology, the
in the filed of printing industry in China
Various options of delivery for your choice